Electrical + Circuits
Moisture protection that drives out moisture and prevents short circuits in electrical equipment.
- Professional product
- Drives out moisture
- Flexible film
- Works in 2–3 minutes
- Displaces moisture and prevents short circuits; effective 2-3 minutes after spraying
- Effective life 12 months (up to 2 years static)
- Dielectric strength 163-256 kV/cm
Pick up at Síðumúli 1 or delivery with Pósturinn or Dropp.
Key features
Electrical + Circuits is an oil-based protection that drives out moisture and prevents short circuits in electrical equipment. It works 2 to 3 minutes after spraying and forms a flexible, wet film that does not harden.
It suits both protecting equipment and restoring it after moisture, in circuits, connectors, motors, ignition systems, junction boxes and refrigeration equipment, in boats, machinery, agriculture and industry. It can be used on moving parts because the film is flexible.
The product is for professionals. It is not suited to exposed outdoor circuits where dust collects, and the dry film version is better there.
- Drives out moisture and prevents short circuits
- Works 2 to 3 minutes after spraying
- Flexible film that does not harden
- Protects equipment or restores it after moisture
- Up to 2 years where stress is low, about 12 months on moving parts
- One coat by spray, dipping or brush
Suitable for
- Circuits, connectors, wires, motors, ignition systems, windings and fuses
- Switchgear and junction boxes
- Refrigeration and freezer equipment, outdoor power points and underground junction boxes
- Equipment in boats, machinery, agriculture and industry
Not suitable for
- Live or hot circuits during application
- Exposed outdoor circuits where dust collects, where the dry film version suits better
- Use with other waterproofing products
| Product number | 44 |
|---|---|
| Category | Electrical |
| Sizes | 125 ml, 250 ml, 1 L, 2 L, 5 L, 20 L |
| Coverage | About 20 to 30 ml per square metre as a thin film. |
| Lifetime | Up to 2 years where stress is low and about 12 months on moving parts. Lifespan depends on the material, use and how the surface is maintained. |
| Drying and curing | Works after 2 to 3 minutes. The product is stable after 10 minutes and the equipment must not be switched on before then. |
Source: manufacturer's technical data sheet.
Directions for use
- Unplug the equipment and switch off the power. Wipe off visible moisture when repairing, or clean off contaminants when protecting.
- Spray a thin, continuous film at about 45 degrees from 20 to 25 cm. Rotate the part 90 degrees and repeat. You can also dip or brush. One coat.
- Wait 2 to 3 minutes before switching on. The product is stable after 10 minutes.
Good to know
- In very cold conditions it takes a little longer to reach full effect.
- Store the container closed and away from light at 5 to 25 °C.
Safety
- Do not apply to live or hot circuits. Keep away from ignition sources.
- Irritates the skin and eyes. Harmful if inhaled and may cause respiratory irritation.
- Keep out of reach of children. Read the safety data sheet (SDS) before use.
Questions and answers
Can I spray equipment that is plugged in?
No. Unplug the equipment and switch it off before you apply. Wait 2 to 3 minutes before switching on, preferably 10.
What is the difference between this and the dry film version?
This product is oil-based and forms a wet, flexible film that suits moving parts. The dry film version leaves a dry film and suits exposed circuits where dust must not stick.
How long does the protection last?
Up to 2 years where stress is low and about 12 months on moving parts.
Videos
Videos from Nanoman, in English.