Electrical + Circuits Dry Film Finish
A dry, flexible film that protects electrical equipment from moisture and corrosion and does not attract dust.
- Professional product
- Dry film
- Does not attract dust
- Touch dry, 2 hours
- Moisture and corrosion protection; dry film does not attract dust; touch dry 2 h
Pick up at Síðumúli 1 or delivery with Pósturinn or Dropp.
Key features
This moisture protection leaves a dry, flexible and abrasion-resistant film that protects electrical equipment against moisture and corrosion. The film does not attract dust, so it suits circuits and equipment outdoors where dust must not collect.
It is touch dry after about 2 hours and ready for use after 10 minutes. It suits circuit boards, junction boxes, switchgear and equipment in boats, mines, railways and telecoms.
The product is not for moving parts. It is flammable and hazardous, so use protective equipment, work in a well-ventilated area and read the safety data sheet before use.
- Dry, flexible and abrasion-resistant film
- Protects against moisture and corrosion
- Does not attract dust
- Touch dry after about 2 hours
- For circuit boards, junction boxes and outdoor equipment
- Up to 2 years where stress is low
Suitable for
- Circuit boards and electronic equipment
- Outdoor electrical equipment and equipment where dust must not stick
- Junction boxes and switchgear
- Equipment in boats, mines, railways and telecoms
Not suitable for
- Moving parts
- Live or hot circuits during application
- Use with other waterproofing products
| Product number | 45 |
|---|---|
| Category | Electrical |
| Sizes | 125 ml, 250 ml, 1 L, 2 L, 5 L, 20 L |
| Coverage | About 20 to 30 ml per square metre as a thin film. |
| Lifetime | Up to 2 years where stress is low. Lifespan depends on the material, use and how the surface is maintained. |
| Drying and curing | Touch dry after about 2 hours and ready for use after 10 minutes. Best performance is reached after up to 24 hours. |
Source: manufacturer's technical data sheet.
Directions for use
- Unplug the equipment and switch off the power. Clean off contaminants following the equipment manufacturer's cleaning recommendations.
- Spray a thin, continuous film at about 45 degrees from 20 to 25 cm. Rotate the part 90 degrees and repeat. You can also dip or brush. One coat.
- Wait 10 minutes before switching on. Best performance is reached after up to 24 hours.
Good to know
- In very cold conditions it takes a little longer to reach full effect.
- Store the container closed and away from light at 5 to 25 °C.
Safety
- Highly flammable. Keep away from heat and flames. No smoking.
- May be fatal if swallowed and enters the airways. Toxic to aquatic life with long-lasting effects.
- Do not apply to live or hot circuits. Read the safety data sheet (SDS) before use.
Questions and answers
What is a dry film?
The moisture protection leaves a dry, flexible film that does not attract dust. That is why it suits exposed circuits and outdoor equipment.
Can I use it on moving parts?
No, it is not intended for moving parts. For those, the oil-based version, Electrical + Circuits, is the right choice.
Is the product flammable?
Yes. It is highly flammable and counts as dangerous goods in transport. Keep it away from heat and flames and read the safety data sheet before use.
Videos
Videos from Nanoman, in English.